LEGO Crane Pulleys: Why an Extra Wheel May Not Make Lifting Easier

Published

An extra pulley on a LEGO crane doesn't automatically reduce the effort needed to lift its toy load. What matters is where the string runs and whether the pulley moves with the load. A wheel that isn't part of the useful string path may just add weight.

LEGO Education makes that point in its Fishing Rod lesson. An added pulley that isn't used by the rigging makes the toy fish harder to lift. Re-routing the string through a fixed and a moving pulley creates a different arrangement that reduces the required effort.

A fixed pulley changes where you pull

A fixed pulley stays in place while rotating around its axle. In a simple arrangement with the string passing over it, you can pull down on one end to move the load up on the other.

That is a change in direction, rather than a reduction in the ideal force needed. LEGO Education's fixed-pulley principle model gives it a mechanical advantage of one. It can still be useful because it puts the pulling end where you can reach it.

A moving pulley shares the support

In the simple two-strand arrangement, one end of the line is anchored, the line passes around a pulley that moves with the load, and the free end is pulled. Two line sections support the moving pulley.

Ignoring friction and the weight of the moving pulley, each supporting section carries half the load force. LEGO Education's corresponding model has a mechanical advantage of two: the effort is halved, but twice as much string must be pulled.

A fixed pulley can redirect the free end of this arrangement without adding another ideal force reduction. Follow the supporting sections around the moving pulley rather than assuming that every wheel doubles the advantage.

Allow twice the line travel

Suppose the toy load needs to rise 10 centimetres in that simple two-strand setup. Each supporting section shortens by 10 centimetres, so the pulling end must take up 20 centimetres of string. That's an ideal geometry calculation, not a measured result from a particular LEGO crane.

If your reel was sized for the earlier direct lift, check that it can take up the additional line. The movement may now require more handle turns. Easier lifting and slower progress are the two sides of the same change.

Check the actual route before changing the reel

Support the toy load near the tabletop and trace the line from its anchor to its free end. Identify which pulley stays on the frame, which moves with the load and where each line section bears on the moving assembly.

Check that the string sits in the pulley grooves and has room to travel. The Fishing Rod lesson also asks builders to loosen overly tight bushings so the reel and pulley wheels can rotate freely. Unwanted friction can hide the benefit of a correctly arranged moving pulley.

Lifting and holding remain separate jobs

This arrangement changes the effort and string travel during a lift. It doesn't, by itself, say what happens when you release the crank. Use the model's intended holding and reset mechanism, keeping the toy load supported while making adjustments.

For the illustrated principle, compare the fixed and moving examples in LEGO Education's pulley lesson with the re-rigging in its Fishing Rod. Follow the string path in your toy build before changing the reel or adding another pulley.